The start of saturation of the particle filter is indicated by the temporary illumination of this warning lamp accompanied by a warning message in the screen.
As soon as the traffic conditions permit, regenerate the filter by driving at a speed of at least 40 mph (60 km/h) until the warning lamp goes off.
If the warning lamp stays on, this indicates a low additive level.
On a new vehicle, the first particle filter regeneration operations may be accompanied by a "burning" smell, which is perfectly normal.
Following prolonged operation of the vehicle at very low speed or at idle, you may, in exceptional circumstances, notice the emission of water vapour at the exhaust on acceleration. This does not affect the behaviour of the vehicle or the environment.
Nissan Micra. Drive belt
HR16DE engine
Water pump pulley
Generator pulley
Crankshaft pulley
Air conditioner compressor pulley (if so
equipped) /Idler pulley (if so equipped)
Manual tensioner pulley
Tensi ...
Fiat Punto. Fuse location
The fuses of the car are grouped into two fuse boxes to be found respectively
on the dashboard and in the engine
compartment.
Fuse box on the dashboard
Loosen the two screws (A) and open the cove ...
Renault Clio. Electronic stability program
(ESC) with understeer control
and traction control
Electronic stability control ESC
This system helps you to keep control
of the vehicle in critical driving conditions
(avoiding an obstacle, loss of grip
on a bend, etc.).
Operating principle
A s ...