B-Class car manuals
Mazda 2: Turning the Engine Off - Start/Stop Engine - When Driving - Mazda2 Owners Manual

Mazda 2: Turning the Engine Off

Mazda2 Owners Manual

WARNING

Do not stop the engine while the vehicle is moving: Stopping the engine while the vehicle is moving for any reason other than in an emergency is dangerous. Stopping the engine while the vehicle is moving will result in reduced braking ability due to the loss of power braking, which could cause an accident and serious injury.

  1. Stop the vehicle completely.
  2. (Manual transaxle) Shift into neutral and set the parking brake.

    (Automatic transaxle) Shift the selector lever to the P position and set the parking brake.

  3. Press the push button start to turn off the engine. The ignition position is off.

CAUTION

When leaving the vehicle, make sure the push button start is off.

NOTE

  • The cooling fan in the engine compartment could turn on for a few minutes after the ignition is switched from ON to OFF, whether or not the A/C is on or off, to cool the engine compartment quickly.
  • When the push button start is pressed from ON to ACC or OFF, the KEY indicator light (green) may fl ash for approximately 30 seconds indicating that the remaining battery power of the key is low.

      Replace with a new battery before the key becomes unusable.

      Refer to Key Battery Replacement on page 6-41 .

  • (Automatic transaxle)   If the engine is turned off while the selector lever is in a position other than P, the ignition switches to ACC.

Emergency Engine Stop

Continuously pressing the push button start or quickly pressing it any number of times while the engine is running or the vehicle is being driven will turn the engine off immediately. The ignition switches to ACC.

    Emergency Operation for Starting the Engine

    i-stop

    Other info:

    Renault Clio. Parking sensor
    Operating principle Ultrasonic detectors, installed in the rear bumper (depending on the vehicle), measure the distance between the vehicle and an obstacle whilst reversing. This measurement is ...

    Mazda 2. Tyre Pressure Monitoring System
    The Tyre Pressure Monitoring System (TPMS) monitors the air pressure of all four tyres. If the air pressure of one or more tyres is too low, the system warns the driver by indicating the tyre pr ...

    Peugeot 208. Operating fault
    In the event of a speed limiter fault, the speed is cleared resulting in flashing of the dashes. Have it checked by a PEUGEOT dealer or a qualified workshop. On a steep descent or in the event of ...

    Manuals For Car Models


    © 2016-2024 Copyright www.b-auto.net 0.0158