
Proceed as follows:
and
will light up on the instrument
and
to go out.The hotter the engine is, the quicker this will happen;
Release the key as soon as the engine starts.
If, when the ignition key is on MAR, warning light
remains lit, turn the key to STOP and then back to
MAR; if the warning light remains on, try with the
other keys provided with the car.
If you still cannot start the engine, contact Fiat Dealership.
IMPORTANT Never leave the ignition key at MAR when the engine is off.
The warning light
will flash for 60 seconds at
start-up or during prolonged cranking to signal a fault in the glow plug heating system. You can use the car as usual if the engine starts but you should contact a Fiat Dealership as soon as possible. |
Mazda 2. Rear Window Wiper and Washer
The ignition must be switched ON to use
the wiper.
Rear Window Wiper
Turn the wiper on by turning the rear
wiper/washer switch.
Rear Window Washer
To spray washer fl uid, turn the rear wipe ...
Peugeot 208. Dynamic stability control (DSC)
Activation
This system is activated automatically each time the vehicle is started.
It comes into operation in the event of a grip or trajectory problem.
This is indicated by flashing of
this wa ...
Mazda 2. When Liftgate/Boot Lid Cannot be
Opened
If the vehicle battery is dead or there is a
malfunction in the electrical system and
the liftgate/boot lid can not be opened,
perform the following procedure as an
emergency measure to Open it:
...