
Various automatic lighting functions are also available depending on options:
- guide-me-home lighting,
- cornering lighting,
- welcome lighting,
- daytime running lamps,
- automatic illumination of headlamps,
In some weather conditions (e.g. low temperature or humidity), the presence of misting on the internal surface of the glass of the headlamps and rear lamps is normal; it disappears after the lamps have been on for a few minutes.
Selection ring for main lighting mode
Turn the ring to position the symbol required facing the mark.

Model without AUTO lighting

Model with AUTO lighting


Stalk for switching headlamps
Pull the stalk to switch the lighting between dipped / main beam headlamps.
In the lighting off and sidelamps modes, the driver can switch on the main beam headlamps temporarily ("headlamp flash") by maintaining a pull on the stalk.
Displays
Illumination of the corresponding indicator lamp in the instrument panel confirms the lighting switched on.
Foglamps selection ring
The foglamps operate with dipped and main beam headlamps.


Rear foglamp only


Front foglamps and rear foglamp
Rotate and release the ring:
When the headlamps switch off with automatic illumination of headlamps (AUTO model) or when the dipped beam headlamps are switched off manually, the foglamps and sidelamps remain on.
Turn the ring rearwards to switch off the foglamps, the sidelamps will then switch off.
In good or rainy weather, both day and night, the front foglamps and the rear foglamp are prohibited. In these situations, the power of their beams may dazzle other drivers. They should only be used in fog or snow.
In these weather conditions, it is your responsibility to switch on the foglamps and dipped beam headlamps manually as the sunshine sensor may detect sufficient light.
Do not forget to switch off the front foglamps and the rear foglamp when they are no longer necessary.
Switching off the lamps when the ignition is switched off
On switching off the ignition, all of the lamps turn off immediately, except for dipped beam if guide-me-home lighting is activated.
Switching on the lamps after the ignition is switched off
To reactivate the lighting control, rotate the ring to the "0" position - lamps off, then to the desired position. On opening the driver's door a temporary audible signal warns the driver that the lighting is on. The lamps, with the exception of the sidelamps, switch off automatically after a maximum duration of thirty minutes to prevent discharging of the battery.
Fiat Punto. Brake fluid
Unscrew cap and check that the fluid level in the reservoir is at
maximum.
Fluid level in the reservoir shall not exceed the MAX mark.
If fluid has to be added, it is suggested to use the brake ...
Skoda Fabia. Brake fluid
WARNING
The engine compartment of your car is a hazardous area. While
working in
the engine compartment, be sure to observe the following warnings
» page 139.
Do not continue
your jo ...
Peugeot 208. Airbags
System designed to maximise the safety of the occupants (with the exception of
the rear centre passenger) in the event of violent collisions. It supplements the
action of the force-limiting seat b ...