Peugeot 208: Battery
Peugeot 208 Owners Manual
Procedure for charging your battery when it is flat or for starting the engine using another battery.
The presence of this label indicates the use of a 12 V lead-acid battery with special technology and specification, for which the involvement of a PEUGEOT dealer or qualified workshop is required when replacing or disconnecting the battery. Failure to observe this recommendation may cause premature wear of the battery.
After refitting the battery, the Stop & Start system will only be active after several hours depending on the climatic conditions and the state of charge of the battery (up to about 8 hours).
Other info:
Fiat Punto. Code card (where required)
The car is delivered with two copies of the key and the CODE card
which bears the following:
the electronic code (A) to be used for emergency starting (see
“Emergency starting” in section ...
Fiat Punto. General
The fuse is a protective device for the electric system: it comes into
action (i.e. it cuts off) mainly due to a fault or improper action on the
system.
When a device does not work, check the ...
Nissan Micra. Changing engine coolant
A NISSAN dealer can change the engine coolant.
The service procedure can be found in the
NISSAN Service Manual.
Improper servicing can result in reduced
heater performance and engine overheati ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia - Honda Pilot
- Volkswagen ID4
- Toyota Prius
