Peugeot 208: Locking the vehicle with full alarm system
Peugeot 208 Owners Manual
Activation
Switch off the ignition and get out of the vehicle.
Press the locking button
on the remote control.
The monitoring system
is active: the indicator lamp in the button flashes once per second.
After the locking button on the remote control is pressed, the exterior perimeter monitoring is activated after a delay of 5 seconds and the interior volumetric monitoring after a delay of 45 seconds.
If an opening (door, boot...) is not closed fully, the vehicle is not locked but the exterior perimeter monitoring will be activated after a delay of 45 seconds at the same time as the interior volumetric monitoring.
Deactivation
Press the unlocking
button on the remote control.
The alarm system is
deactivated: the indicator lamp in the button goes off.
Other info:
Fiat Punto. Refitting the standard wheel
Proceed as follows:
Following the procedure described previously, raise the car and
remove the spare wheel;
Make sure the contact surfaces between wheel and hub are clean so
that the fas ...
Fiat Punto. Emergency start-up
If the Fiat CODE system fails to deactivate engine
immobilising system the warning lights
and
stay on and the engine cannot be started.
To start the engine the emergency start-up can be
perfo ...
Nissan Micra. Locking with power door lock switch
(if so equipped)
To lock all the doors without a key, push the door
lock switch to the lock position 1 . When locking
the door this way, be certain not to leave the key
inside the vehicle.
To unlock all the ...
Manuals For Car Models
-
Chevrolet Sonic -
Citroen C3 -
Fiat Punto -
Honda Fit -
Mazda 2 -
Nissan Micra -
Peugeot 208 -
Renault Clio -
Seat Ibiza -
Skoda Fabia - Honda Pilot
- Volkswagen ID4
- Toyota Prius
